Computer Not Starting With The Power Button.

Follow These Simple Steps...

One of the most common problems with desktop computers is that many times it don't start when we click the Power ON button, and we carry it for repairing. MAY BE THERE IS NO PROBLEM IN YOUR PC... yes, because of lots of wires we have to confront problems. But now whenever your PC doesn't start look at this guide. And check whether all steps are being followed.  I insure you that you will not face this problem any more..

This is the most influencial way to get rid of these problems.

1. Firstly, check whether the Pin Power Code is supplying power to the C.P.U. or not.You can do checking of Pin Power Code by a multimeter.
2. Secondly, may be that the Micro Power button is not working,
   so you have to check it. Most probably be that carbon or dirt get settled there/li>
3. On the MOTHERBOARD the place where the power switch is fixes there two wires rigged to the Switch, shot them by bringing them in contact of each other. After that if the PC starts than the problem is with the Power ON button. In this case it depends on you whether you rig a new button or just clean it evenly and rig it again. It will be better to buy a new one.
4. If the Power ON switch is good than check the SMPS (Switch Mode Power Supply) to check SMPS tug all 20-24 power port out of the motherboard.
   After bringing it out bring the green and black wire in contact of each other, after being shot if the SMPS Fan starts working then there is no problem with it.                                                                                                                    
5. (To shot two wire, electricity is required)
6. (The following steps should be performed in the guidance of elders. The shoting can cause electric shock.)
   If the problem persists.  Then your PC may be damaged , In such case you should carry your PC for repairing..
   Regards.